1966 Mustang Project Car

1966 Mustang Project Car
This 1966 Ford Mustang is for sale for $2,500 in Lone Jack, Missouri. It has 0 miles with a Clear title and is with a interior.
1966 Mustang Coup (Kansas City Area)
Body:
I have had a good bit of body work competed with only a couple of areas that need attention. Around the gas tank in the trunck has some rust and needs repaired. Also the rear floor pans need to be replaced. I have the left floor pan. The right floor pan was replaced but they did a poor job it needs to be re-worked. The roof had some rust from the original vinyl top but it has been repaired. I have over $13k invested over the years but it is time for someone to breath new life into this classic.  New Left front fender
New right front fender
New left quarter panel
New right quarter panel
Drivers door great shape
Passenger door good shape (have new skin if needed)
Tail light panel rough shape (have new panel)
New Front fiberglass valance 2 styles
New rear valance
New front bumper
New rear bumper
New Fiberglass Shelby hood
New Fiberglass Shelby style trunk lid
Roof good shape
Trunk area needs some repair (have a new fuel tank in the box)
Rear floor pans need some work (have the left pan)
Front floor pans are in great shape
Glass
Windshield Glass
Drivers: door, vent and rear
Passenger: door, vent and rear
No rear glass
Engine & Compartment:
Engine is a 302 that I had rebuilt in 1992 and has about 5k miles on it. (It came with the car when I purchased it) Transmission is a C4 and was rebuilt at the same time as the engine. The engine needs new lifters and both engine & Trans would need new seals but should be good to go other than that. I have alot of chrome engine parts as well as a set of 351 E7TE heads that I was going to install. I had also planned to install a roller cam and lifters. There are $3300 in engine parts and fiberglass that are mostly still in the box and never installed. The fiberglass body parts have been installed but not used on the road so still in great condition. Engine Block 302 w heads-ready to put back together
C4 Transmission-would need new seals
Stock 302 Heads
351 E7TE heads (Rebuilt In Box)
Chrome Oil Pan (New In Box)
Chrome Starter (New In Box)
Aluminium Pulley Set (New In Box)
Chrome Water pump (New In Box)
Aluminium Valve covers & Oval Air Cleaner (New In Box)
Chrome 140amp alternator (New In Box)
Engine wiring harness
Edelbrock Performer aluminium intake
Mallory dual point ignition
Holly 4bbl carb
351 engine with marine GT40 marine heads included (needs rebuilt)
Suspension Steering & Brakes
Brakes need new cylinders and master cylinders
Suspension is tired and would need rebuilt 
I would replace all the ball joints to be safe
Power Steering Components
Electrical, Guages & interior
Original wiring harness
Original Guages
Original interior

1966 Ford Mustang : 1966 Mustang Project Car

1966 Ford Mustang : 1966 Mustang Project Car

1966 Ford Mustang : 1966 Mustang Project Car

1966 Ford Mustang : 1966 Mustang Project Car

1966 Ford Mustang : 1966 Mustang Project Car

1966 Ford Mustang : 1966 Mustang Project Car

1966 Ford Mustang : 1966 Mustang Project Car

1966 Ford Mustang : 1966 Mustang Project Car

1966 Ford Mustang : 1966 Mustang Project Car

1966 Ford Mustang : 1966 Mustang Project Car

1966 Ford Mustang : 1966 Mustang Project Car

1966 Ford Mustang : 1966 Mustang Project Car